Xerox WorkCentre 3335 Printer Driver. I have been looking at the Xerox WorkCentre 3335/3345 for the home for years, but everything was delaying the acquisition, since there are MFPs at work and could always use it if there is no hurry. But the time goes the children are growing and the school time begins, as a consequence of having a home at least a printer is a tough necessity. A couple of years ago, before the jump in the $ rate, I was only looking at color multifunction devices, but the current $ rate made adjustments, the more complete the set of cartridges for a color MFP is comparable to the cost of the printer itself. Yes and thought came to the conclusion that color printing is not so much and necessary, if you want, you can have several sheets outside the house. When I receive, I do not get a small square box with a length of the face of about 0.5 m, as a result, barely got into the front seat of a light car, because the trunk does not climb the height. Consider the dimensions of the box when you go to receive it. The Xerox WorkCentre 3335 DNI laser MFP is well packed, there are a lot of blue safety sticky years that prevent accidental opening and rattling during transportation.
Xerox WorkCentre 3345 Driver Download
And the Xerox WorkCentre 3345 MFP itself is wrapped in a package. In addition to the MFP with a cartridge inside it goes: On the front side are USB 2.0 and the printer control panel (both conventional buttons and a color touch screen). A protective film is located on the touch screen, which is removed before switching on. To open the cartridge, open the cartridge door by pressing the button at the top of this door. Opening it and removing the protective foam and pulling a black sheet behind the ribbon, I take out the cartridge and carefully remove the yellow plastic clip, and then pull out one more ribbon on the side. Then put the cartridge in place and close the door. Then connect the power and the connection cable or USB interface to connect to the computer, or a normal twisted pair via the RG-45 to connect to the network router. You can also make a wireless connection over the Wi-Fi interface. Then you can turn on the Xerox WorkCentre 3335 DNI MFPs from the rear, then you do not need to turn it off, because there is an additional option to turn off the control panel (as on the computer’s system units). In general, I make the first inclusion and configuration of the main parameters of this MFP.
Mac OS Driver: