Canon Pixma iP4840 Printer Driver. It took days to disassemble the printer Canon Pixma IP4840. Now with most printers body removed without loosening the screws. Everything is made on the snap. It’s comfortable. Really do not know the location of most of these clips can be broken, not only the body but also the brain itself. Therefore, the following quote with photos step by step dismantling. Perhaps someone will help. And as the same parse this Pixma IP4840? To start viewing twist the printer from all sides and come to the conclusion that should start with removing the decorative caps on the printer cover. (1) Insert a thin flathead screwdriver into the hole (2) raise a little screwdriver up, acting as a lever (3) moves the cover. Similarly we proceed with the second plug. Upper hinged cover, in principle, can not shoot, but I took off.
Canon Pixma iP4840 Driver Download
I am doing it this way: holding point A we raise up the outer edge of the lid (point B) until removed from the shaft. I do the same with the other hand. It is time to remove the side panel. Left and right panel have a slightly different structure from each other, but equally removed. Push the two latches and open the side wall. Below there is a round recess in which the fixed sidewall. Now you can proceed directly to the upper part of the body, which we obtain by removing access to the printer mechanism. This part is held four catches. The two rear and the two front seats. Latches quite fragile , so do not use force. To open them enough light pressure. By the way: Many of the problems with computers help solve computer help forum for beginners . There is always a lot of useful information.